Thingiverse
USB Microscope stand
von Buster44
82
Downloads
80
Likes
0
Makes
The base and clamp were design for USB microscope with a 33mm diameter and a 11" Articulating Magic Arm purchased from ebay. The camera I have was purchased from Maplins but widely available ebay.
The base was designed for a M6 with hex pattern underneath, I found this unnecessary after printing as the M6 bolt on the arm self taps into the base.
The base was designed for a M6 with hex pattern underneath, I found this unnecessary after printing as the M6 bolt on the arm self taps into the base.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
