USBasp Case

This case is meant to be used with the USBasp V2.0 programmer from LC Technology.
The USBasp is a USB in-circuit programmer for Atmel AVR controllers and e.g. can be used if you brink your Anet main board while trying to update the firmware.

You can either print the lid with a translucent filament or you can use any other normal color. In case of normal color open the small holes with a sharp knife to see the led status.

Two small 2mm self tapping screws 8-10mm in length are needed to assemble the case. Two regular M2 screws will also work. Use a sharp knife to free up the holes in the lid first.

Please let me know if you have a problem with the design so I can improve it if necessary.

Also please post a picture with comments if you have made one.

Thanks.

Leo