Thingiverse
UT47.2 Case
by skwrl
0
Downloads
2
Likes
0
Makes
I designed a top mount case for the UT47.2 https://www.reddit.com/r/MechanicalKeyboards/comments/1dynjae/designed_and_3d_printed_a_top_mount_ut472_case/
The alignment pins are maybe unnecessary but help keep the top and bottom halves aligned during assembly. They may need a tiny bit of sanding on the top and bottom edges depending on how well they're printed.
The wrist rest is hollowed out to double as a keyboard cover for travel. Can probably wrap a rubber band around them to keep them together. There are cutouts on the bottom of the wrist rest for 4mm x 2inch strips of adhesive nonslip silicone pads (this is what I have on hand but you can remodel to use bump-ons too).
Prints flat and in one piece on the bed rotated 45 degrees on an X1C.
Hardware used:
\#2x1/4 screws and 6x2.8x1.6 orings (or similar) for the top mount
\#2x3/8 screws for assembling top and bottom case.
8mm bump-ons for feet
silicone strips for wrist rest feet.
The alignment pins are maybe unnecessary but help keep the top and bottom halves aligned during assembly. They may need a tiny bit of sanding on the top and bottom edges depending on how well they're printed.
The wrist rest is hollowed out to double as a keyboard cover for travel. Can probably wrap a rubber band around them to keep them together. There are cutouts on the bottom of the wrist rest for 4mm x 2inch strips of adhesive nonslip silicone pads (this is what I have on hand but you can remodel to use bump-ons too).
Prints flat and in one piece on the bed rotated 45 degrees on an X1C.
Hardware used:
\#2x1/4 screws and 6x2.8x1.6 orings (or similar) for the top mount
\#2x3/8 screws for assembling top and bottom case.
8mm bump-ons for feet
silicone strips for wrist rest feet.
skwrl also publishes on
3 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
