Thingiverse
V-Block
door Sagittario
85
Downloads
41
Likes
0
Makes
This is a simple v block, I designed it for using to saw tubing.
To prevent it sliding around when sawing, the bottom edge has a lip to allow it to locate on the edge of a table or sawhorse etc.
It is surprisingly tough even with 15-20% infill and 3 shells (1.2mm)
To prevent it sliding around when sawing, the bottom edge has a lip to allow it to locate on the edge of a table or sawhorse etc.
It is surprisingly tough even with 15-20% infill and 3 shells (1.2mm)
Sagittario publiceert ook op
76 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
