Thingiverse
V2 Compressed Air Engine (INSANE PREFORMANCE)
di AxelDayton
32
Download
44
Likes
0
Makes
This is a response to my bad V1 engine. This engine runs at 5000 rpm at 40rpm. It also sounds amazing! This engine is 2.2cc's and doesn't use pushrods. The build is also straight-forward and compact.
Check out my channel:
https://youtube.com/c/axeldayton
Links:
Engine Build: https://youtu.be/3rphVOjEvbU
Engine in action: https://youtu.be/CaItl07s53E
To build this engine, you will need:
8 M3x20 Screw (head and bottom end)
4 M3 Locknuts (Bottom end)
6 M5x25 Screw (flywheel)
1 M3x10 screw (piston)
1.5mm Rubber sheet (gaskets)
4.7mm ball bearing (for airtight seal)
2L Soda bottle
Tubeless presta valve (for bikes)
Bike pump or compressor
Silicone based lubricant (I used bike chain lubricant)
3.8mmID 5.2mmOD O-rings
CA glue (superglue)
Check out my channel:
https://youtube.com/c/axeldayton
Links:
Engine Build: https://youtu.be/3rphVOjEvbU
Engine in action: https://youtu.be/CaItl07s53E
To build this engine, you will need:
8 M3x20 Screw (head and bottom end)
4 M3 Locknuts (Bottom end)
6 M5x25 Screw (flywheel)
1 M3x10 screw (piston)
1.5mm Rubber sheet (gaskets)
4.7mm ball bearing (for airtight seal)
2L Soda bottle
Tubeless presta valve (for bikes)
Bike pump or compressor
Silicone based lubricant (I used bike chain lubricant)
3.8mmID 5.2mmOD O-rings
CA glue (superglue)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
