Valve Stem Puller

Ever tried to put new tubes in your (insert vehicle that has tubes) and had trouble getting the valve stem through the hole?
Too cheap to buy a $10 tool that pulls it through for you?
Dont want to wait 2 days for your amazon prime shipping?

Look no further! Print this bad boy, throw some wire or string through the hole, tie a knot in it (give it a few tugs to make sure your knot is tight and wont pull through), and bam! Youve got your very own valve stem puller for a few cents.


Use it like this one.
https://www.amazon.com/BikeMaster-Tire-Valve-Stem-Puller/dp/B004RFT3KM
https://www.youtube.com/watch?v=OMMsMIH5ads
Feed it through the hole, loop it out, thread it in to the step with the valve removed (there are no threads, its just an interference fit, so you may need to make it a bit bigger or smaller depending on your printer's accuracy), and give it a nice, GENTLE pull. GENTLE! Remember, its plastic and may break. One more time... GENTLE!