Venegade Sample Spool

I have printed several sample spool holders off Thingiverse that fit makerbox samples, and my favorite was the one by Nerys. However I wanted something a little wider and larger, and plus it gave me more practice for designing in scratch in Fusion 360. I put a purple and gray Nerys sample spool next to to my black and blue one to show the size difference.

Both parts take about 6 hours each, no supports required, however supports may help the female half as I had some stringing/unsecure strands that happens when trying to print interior curves at a low angle. I didn't use supports and it turned out fine. Be warned that if you choose to use them you may have a hell of a time removing them lol.

I did include holes on each quadrant of the interior walls, which will line up so you can put the end of the filament to latch on to, then tighten the spool one last time to keep it secure.

And I did include a filament clip based on the profile from agibson2's Ziro filament clip, but desig