Thingiverse
Vented pipe
door zappdoggy
0
Downloads
0
Likes
0
Makes
A remix of the Baxter Jar XL by Donny Baxter.
Bottom of jar is wider for more stability. Lid is thicker for drilling holes for draw hose and bowl assembly. I used a 150mm x 12mm black silicone rubber hose and a 1/2" to 3/8" brass plumbing fitting soldered onto a 110mm long brass 3/8" tube. The jar holds about 450ml of water.
Finger hole on front vents to well above the water line.
I had air leaks around the lid so I made a gasket from 1mm silicone sheet to fit inside lid.
The bowl cup is just for catching any droppings, it can be left loose or glued to lid or bowl stem.
Bottom of jar is wider for more stability. Lid is thicker for drilling holes for draw hose and bowl assembly. I used a 150mm x 12mm black silicone rubber hose and a 1/2" to 3/8" brass plumbing fitting soldered onto a 110mm long brass 3/8" tube. The jar holds about 450ml of water.
Finger hole on front vents to well above the water line.
I had air leaks around the lid so I made a gasket from 1mm silicone sheet to fit inside lid.
The bowl cup is just for catching any droppings, it can be left loose or glued to lid or bowl stem.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!