Thingiverse
VertiBird
94
Downloads
54
Likes
1
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/10viA752liE
The Coast Guard Rescue ship is ready to print too!
https://www.thingiverse.com/thing:4161609
https://www.youtube.com/watch?v=0eCAvSWgvUw
When I was growing up in the 70's these were a very popular toy. The original had a cable that ran to the helicopter and the cable would spin making the blade spin and the helicopter to move up and down. Then another rod would tip the chopper forward or reverse to make the motion move forward or reverse.
This is a little different spin. It has the motor on the helicopter and power wires are run out to the motor. Forward and reverse is accomplished by spinning a separate motor at the pivot joint. The Helicopter motor power travels through a microphone audio jack that can spin freely. This prevents the wires from getting twisted up.
An arduino is required along with 2 potentiometers, a motor driver and a high current 5V regulator.
Detaile
The Coast Guard Rescue ship is ready to print too!
https://www.thingiverse.com/thing:4161609
https://www.youtube.com/watch?v=0eCAvSWgvUw
When I was growing up in the 70's these were a very popular toy. The original had a cable that ran to the helicopter and the cable would spin making the blade spin and the helicopter to move up and down. Then another rod would tip the chopper forward or reverse to make the motion move forward or reverse.
This is a little different spin. It has the motor on the helicopter and power wires are run out to the motor. Forward and reverse is accomplished by spinning a separate motor at the pivot joint. The Helicopter motor power travels through a microphone audio jack that can spin freely. This prevents the wires from getting twisted up.
An arduino is required along with 2 potentiometers, a motor driver and a high current 5V regulator.
Detaile
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
