Thingiverse
Vertical Spool Holder
by CJ000
64
Downloads
49
Likes
0
Makes
This is my Vertical Spool Holder for my M3D Micro. The design of the base was made stronger since I didn't want any flimsy thing holding 2kg of filament on top of my printer.
On this instance I've used high pressure PVC 1/2" inner diameter (21.4mm outer diameter).
The rod has a cover so that it fits well into the bearings and two caps that allow easy slide in/out when changing filament.
The bushings fits a filament spool with inner diameter of 1.25" and it houses a 28mm (outer diameter) bearing.
The bearing's used here have a rubber/plastic cover, which you can see I removed on one of the pictures because it adds a bit of drag. I wanted it to be as smooth as possible so I trimmed about 0.5mm of the inner plastic cover.
The clip helps stabilize the holder by completing the gab under the mount and fastening to it.
Initial ideas inspired by http://www.thingiverse.com/make:129683
On this instance I've used high pressure PVC 1/2" inner diameter (21.4mm outer diameter).
The rod has a cover so that it fits well into the bearings and two caps that allow easy slide in/out when changing filament.
The bushings fits a filament spool with inner diameter of 1.25" and it houses a 28mm (outer diameter) bearing.
The bearing's used here have a rubber/plastic cover, which you can see I removed on one of the pictures because it adds a bit of drag. I wanted it to be as smooth as possible so I trimmed about 0.5mm of the inner plastic cover.
The clip helps stabilize the holder by completing the gab under the mount and fastening to it.
Initial ideas inspired by http://www.thingiverse.com/make:129683
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
