Thingiverse
VertX
von watsdesign
34
Downloads
98
Likes
7
Makes
More on the wiki : http://reprap.org/wiki/X-carriage-struder
That's my vertical x-axis idea of a compact extruder integrated into the x-carriage, thanks to direct drive and linear bearings.
It was designed for the "classic" Sells Mendel, as a sort of upgrade, but it's also compatible with the Prusa Mendel (same spacing between z-rods).
The carriage-extruder is compatible with most of the existing hotends, or just ask for a diameter if your thermal break part (ptfe/peek) don't fit my 13mm.
Recent History
[08/11] Replacing the old x-axis on my Sells Mendel by the VertX 0.7.3 (and major update of the wiki page)
[10/11] First print ! :D www.youtube.com/watch?v=6sF87FcMKyI
[13/11] x-carriage have mounting points now to accept more hotends
[30/11] V0.8 (x-carriage v12, x-end-idler-v9, x-end-motor-v8)
That's my vertical x-axis idea of a compact extruder integrated into the x-carriage, thanks to direct drive and linear bearings.
It was designed for the "classic" Sells Mendel, as a sort of upgrade, but it's also compatible with the Prusa Mendel (same spacing between z-rods).
The carriage-extruder is compatible with most of the existing hotends, or just ask for a diameter if your thermal break part (ptfe/peek) don't fit my 13mm.
Recent History
[08/11] Replacing the old x-axis on my Sells Mendel by the VertX 0.7.3 (and major update of the wiki page)
[10/11] First print ! :D www.youtube.com/watch?v=6sF87FcMKyI
[13/11] x-carriage have mounting points now to accept more hotends
[30/11] V0.8 (x-carriage v12, x-end-idler-v9, x-end-motor-v8)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
