Thingiverse
Vimin Network switch wall mount
por neo8223
0
Descargas
0
Likes
0
Makes
Using the server rack mount screw holes and the original screws, this REALLLY basic design works well.
I printed PETG at 30% infill, seemed to hold well. I did over tighten it when mounting to the wall, but the 2 screw holes per side was ample for the strength.
You can also use the original screws that come with the switch too.
I printed PETG at 30% infill, seemed to hold well. I did over tighten it when mounting to the wall, but the 2 screw holes per side was ample for the strength.
You can also use the original screws that come with the switch too.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!