Vive Tracker Holder

This is designed to hold your Vive Trackers on the wall. Hung using command strips.

There are two versions:
1. Regular - Just made to hold the trackers. Should work with any tracker or strap that you're using.

2. Magnetic Charging - Specifically designed for the Trackstrap Plus. There are holders for magnetic connecters so that all you have to do is slide the trackers in and the magnet should attract to the connector. Simply pull the cable away when you're taking the trackers off the holder. Good for cable management.

I highly recommend using 4 walls (perimeters). I used 25% gyroid for the infill. You could probably go lower, just stick with your gut.

This is specifically designed to print back-side down. No supports should be needed. This is also designed to fit most 3d printers (set "build plate adhesion type" in cura to "None" if you have issues).

I used a .8mm nozzle. You may get better results with a normal .4mm nozzle.