Thingiverse
Voron Printplate bed alignment helper
von kse
0
Downloads
1
Likes
0
Makes
Here you will find an "End Stop" for your Voron Printer that helps you to align your print plate more easily on your printbed.
It just slides over the back curled nut standoffs. The inner bore is designed to be very tight. you might have to drill or grind it a little bit, Make sure it sits tightly on the curled nut, so it does not slide down.
I suggest printing it with a material hat does not get weak on printbed temperature. i printed mine with PACF.
It just slides over the back curled nut standoffs. The inner bore is designed to be very tight. you might have to drill or grind it a little bit, Make sure it sits tightly on the curled nut, so it does not slide down.
I suggest printing it with a material hat does not get weak on printbed temperature. i printed mine with PACF.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
