Thingiverse
Vortex Camera tilt platform
por PB4
7
Descargas
4
Likes
0
Makes
This is a camera tilt platform that encloses a naze 32 board and a servo, therefore requiring only power (from gopro 5v port) from the Vortex.
As the Vortex does not have any tilt outputs, I had to use a separate Naze board.
You can configure the amount of tilt the usual way with cleanflight, you could also make an extension from your Rx to the Naze and access more advanced functions with Aux channels.
THIS BOARD WILL ONLY ACCEPT ONE SIZE SERVO, I used the TURNIGY TGY-210dmh it's 23 x 12 x 25.4 mm.
As the Vortex does not have any tilt outputs, I had to use a separate Naze board.
You can configure the amount of tilt the usual way with cleanflight, you could also make an extension from your Rx to the Naze and access more advanced functions with Aux channels.
THIS BOARD WILL ONLY ACCEPT ONE SIZE SERVO, I used the TURNIGY TGY-210dmh it's 23 x 12 x 25.4 mm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!