votex jet engine

I produced this model on my FDM printer, but I think it would be better on a resin printer. When putting this together, make sure to scale it a bit for the screws, as the holes are 3mm and might need sizing up for your screws. Also, hot glue all the areas that get fitted together. If you want to use this as a water jet engine, it will work, but if you’re not, make sure to put plaster on the inside to insulate the plastic. Make sure if you use this as a jet engine that the smaller hole is for gas and the bigger hole is for air. (For a water jet engine, put a hose in the bigger hole and a bike pump in the smaller hole. Make sure that the hose is not too powerful.)