VZBOT BROR IKEA HACK

3 STL files allowing to enclose and attach a vzbot330 in a ikea bror system shelf

I am still working on enclosure itself. bror 3d model available on internet do not have accurate dimensions so far, so i have to make precise measurement on my own.

Back plate enclosure is particulary difficult because the back of the printer gets partially outside of the shelf.

I use a 65x55 cm bror shelf, attached in a L configuration to a 65x30 cm shelf.
this way the 65x55 is set 10cm away from the wall, which is enough room for the vzbot electronic and cooling system.