Thingiverse
WALL-E (Red LED on front panel)
von ZDC
13
Downloads
13
Likes
0
Makes
Setup to use a 5mm Red LED on the front panel.
I printed the LED cover in a Translucent Red filament.
The LED just slides inside to keep it in place.
I also adjusted the front panel of chillibasket design to have a hole and a area on the inside for the LED wiring to route around the speaker I am using.
I am setting mine up for it flashes ON and OFF with an Alarm sound.
I printed the LED cover in a Translucent Red filament.
The LED just slides inside to keep it in place.
I also adjusted the front panel of chillibasket design to have a hole and a area on the inside for the LED wiring to route around the speaker I am using.
I am setting mine up for it flashes ON and OFF with an Alarm sound.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!