Thingiverse
Wall Gears
door SPEKERDUDE
1
Downloads
4
Likes
0
Makes
VERSION 2 AVAILABLE ! check my page
This is my wall original wall gears project,
-I have included 2 sizes of stands(hubs) of the gears one will make the gear almost flush with the wall the other will make it stand about 10mm away from the wall, as well as a 10mm spacer for more height.
-you can make it manual or powered, i have included a shaft to make it powered I used a gear mechanism pulled out of an older IDE CD-ROM drive to power mine. unfortunately it is unlikely you will be able to find the exact same mechanism I used, but I have included the shaft and gear box just encase.
3D PRINTING SETTINGS
-the gears must be printed in vase/spiralized mode with the default base thickness for curia which works out to around 1.45mm
This is my wall original wall gears project,
-I have included 2 sizes of stands(hubs) of the gears one will make the gear almost flush with the wall the other will make it stand about 10mm away from the wall, as well as a 10mm spacer for more height.
-you can make it manual or powered, i have included a shaft to make it powered I used a gear mechanism pulled out of an older IDE CD-ROM drive to power mine. unfortunately it is unlikely you will be able to find the exact same mechanism I used, but I have included the shaft and gear box just encase.
3D PRINTING SETTINGS
-the gears must be printed in vase/spiralized mode with the default base thickness for curia which works out to around 1.45mm
SPEKERDUDE publiceert ook op
411 extra modellen op 4 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
