Thingiverse
Wall Hook
door FlyByPC
4
Downloads
1
Likes
0
Makes
A simple wall hook, suitable for mounting on drywall via screw holes.
Should print OK with no supports or raft etc. Suggested 0.2mm layer size, though 0.3mm is probably fine, too.
Should print OK with no supports or raft etc. Suggested 0.2mm layer size, though 0.3mm is probably fine, too.
FlyByPC publiceert ook op
29 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
