Wall Light

This is a wall light I designed taking inspiration from an old Philips light model no longer in production.I designed the light on purpose to be extremely easy to install without any screw (except those necessary to fix it to the wall) but only through sliding connections.The base is having a pattern of holes to allow the installation also on uneven surfaces (I designed in this way since i have a stone wall and need to drill holes among stone gaps).I printed it in ABS but would suggest to use ASA for outdoor use.Design is by no means IP6x/Water resistant so cannot be used in direct exposure to rain however should be enough to have it installed in pathos or terraces with partial roof protection.For the white cover I used a white 2 - 3mm acrylic glass. I cut it around 92mm wide and 174 long.I used 0.24 draft mode on Bambu Studio.I suggest tree supports. I tried to minimize supports as much as possible.I prepared two plates in Bambu Studio but you can arrange all pieces in one single plat