Wall Mount with Stapler

This wall mount uses a stapler instead of the traditional screw type wall mount. AttentionYou print with PETG, staples won't go through PLA.Print with a layer height of 0.16mm.If the stapler needles are not cutting properly, try using “MAX No. 10”.Not for use on stone or concrete walls.It cannot be used with some staplers with large heads or staplers that cannot be “opened”.FeaturesNo screws are required for wall mounting.Staples are thin, so the holes left after removal are less noticeable than with screws or pins.Can be mounted on wood or plasterboard walls.It won't hold anything heavy, but it's sturdier than it looks.The slider has two M3 screw holes, if you need other types please comment.It is only 5mm thick.InstallationPrepare your stapler: Load the staples and open the stapler.Print out the wall mount and determine where you want to attach it. In the photo it is temporarily fixed with tape.Place the open stapler over the top of the wall and press the staples vertical