Thingiverse
Wall pot
por BenGolko
30
Descargas
32
Likes
0
Makes
This pot is mounted on my wall using the wall stickers that dont't damage paint. there are two insets for the ends of the strips (ment for removing them) so they are flush with the sides of the pot. I am using it for a spear mint plant for fregerance. It requires no supports as all angles (ecept for the bridging in the insets) are 45 degrees. I used some ceran wrap on the inside for water proofing but if you print it solid this is not required.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
