Thingiverse
Wall Shelf
von JMecky
152
Downloads
165
Likes
2
Makes
Wall shelf designed to be held on with screws or push pins.
I use it to hold up this little wannabe bonsai. Shelf shown in the pictures has been scaled 75% for the hictop. Original was designed to be printed on my FolgerTech, FT-5 jumbo.
I printed using a .8mm nozzle on my HICTOP Prusa I3. Took 75 min.
Its pretty sturdy.
Pot was also printed of thingiverse.
I use it to hold up this little wannabe bonsai. Shelf shown in the pictures has been scaled 75% for the hictop. Original was designed to be printed on my FolgerTech, FT-5 jumbo.
I printed using a .8mm nozzle on my HICTOP Prusa I3. Took 75 min.
Its pretty sturdy.
Pot was also printed of thingiverse.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!