Thingiverse
Wallace G1 3D Printer
von Komb
131
Downloads
109
Likes
0
Makes
NOTE! Upgraded Bed Mounts. Stiffer than previous mounts. May 1 2015
Based on the original Wallace design by whosawhatsis.
With all the Upgrades I've added to mine.
Rack & Pinion X & Y drives.
Spool Hook and Motor stabalizer ends.
Filament guide.
Y-Linerbearings removed from motor blocks
End Stop switch mounts.
And new here, Printable Bed! No board nessessary!
Onlything not included here is the Extruder. I recomend thing:40002 ;)
Current print area: 200x180x200
When I get the longer Y Rods: 200x200x200. That will come with new Bed Rear parts.
BOM and Build instructions started at :
http://gkprotoforms.ca
in How-To section.
Based on the original Wallace design by whosawhatsis.
With all the Upgrades I've added to mine.
Rack & Pinion X & Y drives.
Spool Hook and Motor stabalizer ends.
Filament guide.
Y-Linerbearings removed from motor blocks
End Stop switch mounts.
And new here, Printable Bed! No board nessessary!
Onlything not included here is the Extruder. I recomend thing:40002 ;)
Current print area: 200x180x200
When I get the longer Y Rods: 200x200x200. That will come with new Bed Rear parts.
BOM and Build instructions started at :
http://gkprotoforms.ca
in How-To section.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!