Thingiverse
Wanhao Duplicator 4S door stop
von Crispin
12
Downloads
3
Likes
0
Makes
A little magnetic door stop for the Duplicator 4S. It uses two 5x3mm round neodymium magnets which are for the door attachment (glued on)
The chassis section has a 5mm pin which you need to locate into a 5mm hole you need to drill. It also uses 4 neodymium magnets to hold it in place.
See my other designs if you don't want to drill. (Will void warranty)
The chassis section has a 5mm pin which you need to locate into a 5mm hole you need to drill. It also uses 4 neodymium magnets to hold it in place.
See my other designs if you don't want to drill. (Will void warranty)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
