Thingiverse
Warlayer Pillar Creator
door mrgudenheim
53
Downloads
37
Likes
0
Makes
Bitz to create pillars/corners for Warlayer 4.0 system remixed from other files on thingiverse.
If the bitz are added as sub parts in PrusaSlicer they should be centerd on the pillar and the supports should be at the correct height to support a warlayer roof.
The bottom peg hole cutter can be set as a negative volume to create a slot for the top peg to fit in.
Pillars are named based on slot width. Original warlayer pillar "tighter tolerance" slots are 4.2mm wide, while the pillars in this set have slot widths that range from 3.90 - 4.2mm to offer options for a tighter fit.
These pillars work with these warlayer 4.0 walls: https://www.thingiverse.com/thing:5665319
If the bitz are added as sub parts in PrusaSlicer they should be centerd on the pillar and the supports should be at the correct height to support a warlayer roof.
The bottom peg hole cutter can be set as a negative volume to create a slot for the top peg to fit in.
Pillars are named based on slot width. Original warlayer pillar "tighter tolerance" slots are 4.2mm wide, while the pillars in this set have slot widths that range from 3.90 - 4.2mm to offer options for a tighter fit.
These pillars work with these warlayer 4.0 walls: https://www.thingiverse.com/thing:5665319
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
