Thingiverse
Warning Message
by IanAdd
5
Downloads
2
Likes
0
Makes
This is my first attempt at remix, pushing an stl file into Fusion 360, cleaning up the triangles and so on.
The objective was to achieve what the original picture showed but didn't deliver - at least not in a way that I am aware that my Prusa could do.
By that I mean the Warning section in red, the top of the rest in white and a black base.
Once I had cleaned the Warning area of triangles all i did was add 0.4 mm to the top of the section where the WARNING is shown. Then an additional colour change in the print delivered the red - only in that area.
Enjoy
The objective was to achieve what the original picture showed but didn't deliver - at least not in a way that I am aware that my Prusa could do.
By that I mean the Warning section in red, the top of the rest in white and a black base.
Once I had cleaned the Warning area of triangles all i did was add 0.4 mm to the top of the section where the WARNING is shown. Then an additional colour change in the print delivered the red - only in that area.
Enjoy
IanAdd also publishes on
7 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!