Thingiverse
Warp Guide
by JHGRedekop
6
Downloads
8
Likes
0
Makes
This is a simple warp guide for an Ashford 24" table loom. It hooks around the back beam to keep the warp from spreading out.
To use it, slip some scrap fabric around the back beam and slide the warp guide over it (the fabric helps keep the warp threads from catching. Use a zip-tie to clamp it tight so it doesn't move.
There aren't any special requirements for the print. The holes for the zip-ties are small enough that they shouldn't need supports.
To use it, slip some scrap fabric around the back beam and slide the warp guide over it (the fabric helps keep the warp threads from catching. Use a zip-tie to clamp it tight so it doesn't move.
There aren't any special requirements for the print. The holes for the zip-ties are small enough that they shouldn't need supports.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!