Slicer Discord
Watch Face – 3D-Druckmodell von Thingiverse Thingiverse

Watch Face

von krydasu
0 Downloads
0 Likes
0 Makes
Zum Modell
We have smart watches and noticed our daughter would hold out her arm the same way we do when we hear our watch notification! It is super cute so I made her a little watch.

I made a simple band out of fabric (3" wide x 8"long) that I folded both ends in 1/2" then I folded 1/2" from each long edge, then again to meet in the middle. Then I played with the decorative stitches to hold down the centre seam and along both sides.

Then I stitched on the watch face - to make it extra secure since I'm concerned about it being a choking hazard - I did once around the large circle, went crazy tying a huge knot, then went back to cover the gaps before tying and other huge knot and repeating on the smaller circle.

Then simply add a snap or two to fit your child!

***Recommended for children over 3 years as it is a CHOKING HAZARD***
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen