Thingiverse
Water cooling block
von blender
76
Downloads
63
Likes
0
Makes
This is my idea of an watercooling block for cheap M6 tubes. Right now it is highly **experimental**. I wanted to reduce weight and size of my hotends to the smallest possible ammount.
If this thing works well you can completly remove the heatsinks on hotends. Then a hotend just assembles from this block, an 1$ china tube, heatblock and nozzle.
It is 16mm height and should be printed as fine as any possible to make the tubes strong enough.
**Features**
- Grooves at bottom and top to fit an rubber
- small size (16mm height, 16mm width)
- 2,5 circles to let the water cool as much as possible surface
**Update 2015-10-10**
- added inprint supports. So the slicer doesn`t have to try print support inside of the tubes
If this thing works well you can completly remove the heatsinks on hotends. Then a hotend just assembles from this block, an 1$ china tube, heatblock and nozzle.
It is 16mm height and should be printed as fine as any possible to make the tubes strong enough.
**Features**
- Grooves at bottom and top to fit an rubber
- small size (16mm height, 16mm width)
- 2,5 circles to let the water cool as much as possible surface
**Update 2015-10-10**
- added inprint supports. So the slicer doesn`t have to try print support inside of the tubes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
