Thingiverse
Watercooling for E3D V6
von ChrisPV
13
Downloads
7
Likes
0
Makes
Just put the printed part around your E3D coolerbody and take two zipties to avoid leaking.
you`ll also need 2x 4mm PTFE tube, put them into the connectors for the water tubes.
You have to print this part in TPE (ninja flex) every other material is to hard and not soft
enough
you`ll also need 2x 4mm PTFE tube, put them into the connectors for the water tubes.
You have to print this part in TPE (ninja flex) every other material is to hard and not soft
enough
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
