Thingiverse
Waveshare CM4-IO-POE case
von mint_dulip
3
Downloads
2
Likes
0
Makes
A case for the WaveShare CM4-IO-POE dev board.Has tabs for wall mounting and holes for IO on both sides of board. It is designed to take a 20x40mm noctua fan for silent airflow but other fans with a 32mmx32mm hole spacing for mounting will work. Using this fan as shown in the image above has dropped my porcessor temps by 10C.
Stand off mounts for the MB and case lid holes are design to use M2 self tapping screws.
The lids are currently a work in progress (haven't fully tested the fit yet).
Measured out using claipers, there is some spacning to allow for expansion but I strongly suggest calibrating e-steps, flow rate and dimensional accuracy before printing.
Stand off mounts for the MB and case lid holes are design to use M2 self tapping screws.
The lids are currently a work in progress (haven't fully tested the fit yet).
Measured out using claipers, there is some spacning to allow for expansion but I strongly suggest calibrating e-steps, flow rate and dimensional accuracy before printing.
mint_dulip veröffentlicht auch auf
33 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
