Thingiverse
WD40 Cap
von ilko
4
Downloads
8
Likes
0
Makes
Replacement cap for 400ml WD40 container.
"clic" and it's in place ! If this becomes too hard to remove, then slightly scale it up finely (like +0.5% or +1%).
**NOTE**
This mesh is optimized for 0.2 mm layer height and 0.4 mm nozzle diameter. Wall thickness is 1.2 mm, meaning 3 wall counts (perimeters).
"clic" and it's in place ! If this becomes too hard to remove, then slightly scale it up finely (like +0.5% or +1%).
**NOTE**
This mesh is optimized for 0.2 mm layer height and 0.4 mm nozzle diameter. Wall thickness is 1.2 mm, meaning 3 wall counts (perimeters).
ilko veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!