Slicer Discord
WDT Tool – 3D-Druckmodell von Thingiverse Thingiverse

WDT Tool

83 Downloads
43 Likes
2 Makes
Zum Modell
WDT tool for your espresso puck prep!

![Satisfying](https://media2.giphy.com/media/LiPB82j4TDRkrspFrL/giphy.gif)![WDT](https://media1.giphy.com/media/q901tW62XkVsfMVMlM/giphy.gif)![Store it](https://media1.giphy.com/media/DBuIGzXtTiLrXwD2HJ/giphy.gif)

Additional stuff needed:
- 7x 0.4mm or thinner acupuncture needles with:
- ~30mm or shorter handle (the type without a little knob at the end, like in the photo below)
- ~50mm needle (75mm version of the models also available)
- Version with smaller holes is available if using much thinner needles, like 0.25mm, which also have thinner handles

Bend a little zig-zag into the needles' handles before inserting, and they stay in place well, while still being removable. They are sharp, so be careful!

![Needles](https://i.imgur.com/59ZM1BH.jpg)
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

vjapolitzer veröffentlicht auch auf

1 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen