Webcam / Camera Tripod

This is Racknos' webcam modification https://www.printables.com/model/257031-webcam-camera-tripod of LoboCNC's phone tripod https://www.printables.com/model/132242-zoom-phone-tripod I was silly and printed the legs without a brim. This caused them to bend up at the thin ends but it's still fine, the legs are just skinnier than they should be. The print profile has these parts with a brim. This works great. The legs clip into the base very easily and you lock the legs down with the ring. To adjust the height, simply twist up the ring and pull the legs out more. All parts have 30% gyroid infill and 3 walls for strength. I sliced the legs with 0.2mm layer height for strength, the ring with 0.16mm layer height for a combination of strength and detail (for the coarse screw) and the base with 0.12mm layer height for detail (for the fine screw). Both screws work very well this way. I'm using this for a Raspberry Pi HQ camera, but it will fit any camera with a standard ¼" screw hole. This was