Thingiverse
Webcam Cover
door OverFound
35
Downloads
30
Likes
0
Makes
This a sliding webcam cover i designed to allow easy covering and uncovering of a laptop webcam. This design should fit together well but depending on your printer some after printing sanding may have to be done.
Print Suggestions:
Print the two parts separate
Print the holder with no base and on top of painters tape so after printing you can remove the tape from the build plate and cut out the hole for the webcam (out of the tape) and be able to just stick it right on the laptop.
Warning Some people may have trouble printing because it is set very small its a small glitch that makes programs think inches are millimeters just set the scale to 2540% for full size
Print Suggestions:
Print the two parts separate
Print the holder with no base and on top of painters tape so after printing you can remove the tape from the build plate and cut out the hole for the webcam (out of the tape) and be able to just stick it right on the laptop.
Warning Some people may have trouble printing because it is set very small its a small glitch that makes programs think inches are millimeters just set the scale to 2540% for full size
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
