Thingiverse
Webcam Stand
door jordanbrown
59
Downloads
51
Likes
0
Makes
I had my webcam on my desk, but my boss said he didn't like looking up my nose.
So I built a stand out of a couple of hunks of 2x4, and that was OK but was pretty clunky, so I built this, and it's much smaller and cooler.
It prints flat, so it's quite strong, and press-fits tightly.
Full disclosure: I cleaned up the OpenSCAD file quite a bit in preparation for publication, and I haven't printed it since that cleanup. It looks OK.
So I built a stand out of a couple of hunks of 2x4, and that was OK but was pretty clunky, so I built this, and it's much smaller and cooler.
It prints flat, so it's quite strong, and press-fits tightly.
Full disclosure: I cleaned up the OpenSCAD file quite a bit in preparation for publication, and I haven't printed it since that cleanup. It looks OK.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!