Thingiverse
Webcam Stand
par jordanbrown
59
Téléchargements
51
Likes
0
Makes
I had my webcam on my desk, but my boss said he didn't like looking up my nose.
So I built a stand out of a couple of hunks of 2x4, and that was OK but was pretty clunky, so I built this, and it's much smaller and cooler.
It prints flat, so it's quite strong, and press-fits tightly.
Full disclosure: I cleaned up the OpenSCAD file quite a bit in preparation for publication, and I haven't printed it since that cleanup. It looks OK.
So I built a stand out of a couple of hunks of 2x4, and that was OK but was pretty clunky, so I built this, and it's much smaller and cooler.
It prints flat, so it's quite strong, and press-fits tightly.
Full disclosure: I cleaned up the OpenSCAD file quite a bit in preparation for publication, and I haven't printed it since that cleanup. It looks OK.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !