Thingiverse
Webcam Stand
von wintees
1
Downloads
0
Likes
0
Makes
a simple webcam stand with 2 parts (CAGE, STAND) which i created for my Ultimaker3 (maybe works with other models too? plz let me know!). The built in Webcam is nice, but i wanted an additional one on the top for streams.
So this one is put on the edge of the printer with 2 slots on the back (cage) for wires.
!!! It has a large 50° angle, because otherwise i wouldn't get a nice picture of the whole printing plate. So be careful that your webcam does not fall down into the printer. Check before use, WARRANTY EXCLUDED! Use a tape or sth if u need it to be fixed! ;)
**GLUE** THE CAGE TO THE STAND AT THE POSITION YOU PREFER, IT DOES NOT STICK TOGETHER BY ITSELF!!!
The small hole on the bottom of the CAGE fits to the STAND.
Download and try it out!
HF
So this one is put on the edge of the printer with 2 slots on the back (cage) for wires.
!!! It has a large 50° angle, because otherwise i wouldn't get a nice picture of the whole printing plate. So be careful that your webcam does not fall down into the printer. Check before use, WARRANTY EXCLUDED! Use a tape or sth if u need it to be fixed! ;)
**GLUE** THE CAGE TO THE STAND AT THE POSITION YOU PREFER, IT DOES NOT STICK TOGETHER BY ITSELF!!!
The small hole on the bottom of the CAGE fits to the STAND.
Download and try it out!
HF
wintees veröffentlicht auch auf
15 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
