Slicer Discord
Weedwacker – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Weedwacker

1 Downloads
4 Likes
0 Makes
Zum Modell
Use the weedwacker grinder to grind up any herbs, spices or leafy greens. Uses 18500 or 18650 rechargable batteries with a C charger on the circuit board, push button momentary switch and ceiling fan chain which all can be bought on Amazon, links below of the parts I used. I hot glued the motor and the curcuit board which holds up nice but i'm making holders now so they should just snap into place. Wire the positive from output on charge board to one pin on the button switch, the other pin of switch to the positive on motor, a diode is placed inbetween the negative and positive of the motor and then solder the battery to the charge board.
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS, PETG
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen