Thingiverse
Weight Keeper
von Rohn
23
Downloads
28
Likes
0
Makes
With the spikes on the bottom, this Weight Keeper prohibits the weights from rolling around when they are placed on the ground.
Materials required:
- 4 Printed Components for one dumbell
- 4 M5x10mm bolts and nuts
Future Improvements:
- None yet
Difficulty to print (EASY/MODERATE/HARD):
Easy
Additional:
- Source is in SolidWorks 2013
Poor engineer accepting donations =D
Materials required:
- 4 Printed Components for one dumbell
- 4 M5x10mm bolts and nuts
Future Improvements:
- None yet
Difficulty to print (EASY/MODERATE/HARD):
Easy
Additional:
- Source is in SolidWorks 2013
Poor engineer accepting donations =D
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
