Thingiverse
Wheel
von ThingiJay
1
Downloads
1
Likes
0
Makes
This is a simple wheel with a keyway cut into the hub. It can be used on a vehicle or as a flywheel or turbine. There's a groove on the outside to accommodate an O-ring or drive belt.
If the wheel is printed 200 mm in diameter, the hole in the hub is 20 mm in diameter with an 8 mm deep keyway.
If the wheel is printed 200 mm in diameter, the hole in the hub is 20 mm in diameter with an 8 mm deep keyway.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
