WhoopStrap FPV Camera Mount

A TPU version of the ziptie lowrider mod for the Mobula6 brushless whoop, similar to what they're doing on the Moblite6. I loved the zip tie mod, but I smashed the lens out of the Runcam Nano 3 camera in a week and broke the whole camera in another week (RIP good lens Nano 3). This one has a little TPU around the lens but the new lens on the Nano 3 is so tiny and surrounded by plastic so I think it is a lot harder to break.

Because the camera won't sit all the way back against the frame crossbar (it is too wide to fit in the space), there's a little stub in the 3D print designed to take up the gap to keep the camera pointed roughly straight.

To install: pop the camera in with the ring facing away, insert the fat TPU part through the frame, wrap the long pointy bit back around. Go **over** the fat end bit, then under the space between the two gaps, and back out the other gap. Like you'd thread a strap through a buckle. Pull the tail end tight until you get the camera tilt you want