Wii Sensor Bar Shell

This is a shell for a custom Wii Sensor bar. It's pretty simple and isn't too “robust” (the snapping/guiding mechanism for the 2 parts don't last long, doesn't sustain falls too well, etc.) Recommend Steps:1. Print the 2 parts (front and back), and optionally the stand, and get the necessary components (listed below)2. Press the IR LEDs into their slots (this might be a little difficult depending on tolerances) on the front piece. I recommend orienting the LEDs in such a way that the LED closest to the center of the bar's cathode (shorter leg) can be twisted with the other's anode (long leg) for easy connection. 3. Glue/Press the USB-C Power port into the back slot.4. I personally soldered everything together, however you can make a simple PCB for this. If you want to solder: use thin, flexible wiring (e.g., 22AWG Stranded Core) for connecting everythingThe basic flow is this: 5V (USB-C Power Board) → 100ohm Resistor (or whatever works with your LEDs) → LED → LE