Thingiverse
Wind-Sim Mount
von Rak3tenmann
1
Downloads
2
Likes
0
Makes
I designed it so that it can be attached in a variety of places and the flow direction can be easily adjusted.
You will need a very long (> 25 cm) cable tie. Or you can simply connect two cable ties.
I had previously considered installing a threaded sleeve and securing it even better with a grub screw. In my case, however, it is stable enough.
You will need a very long (> 25 cm) cable tie. Or you can simply connect two cable ties.
I had previously considered installing a threaded sleeve and securing it even better with a grub screw. In my case, however, it is stable enough.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
