Wind Spinner

BEARING VERSION NOW AVAILABLE - https://makerworld.com/en/models/439471#profileId-345050 Here's a straightforward 13inch wind spinner designed for your yard, no bearings required.I might possibly add bearings to this at a later time for a smoother spin but it works fine the way it is.I would recommend printing this in PETG for optimal durability although High Temp PLA could serve as an alternative which is what I used.3/8inch or smaller dowel rod to mount it in the ground.*NOTE* - Would recommend super glue on the Cap screw to keep it from backing out over time. Directions: ( See photo for reference )STEP 1 - Place the wind fins into the puzzle locking "BOTTOM PART".STEP 2 - Screw on the “TOP PART” to connect the fins to the “BOTTOM”STEP 3 - Slide the connected fins onto the “MAIN PART”STEP 4 - Screw on the “CAP PART”STEP 5 - Insert a 3/8inch dowel rod or something close to that size.DONE!Optional Mounting - If you want to mount it horizontally you only need to swap out one