Slicer Discord
Wind Turbine V5 – Modello 3D stampabile da Thingiverse Thingiverse

Wind Turbine V5

186 Download
116 Likes
0 Makes
Vai al Modello
YOUTUBE : https://www.youtube.com/watch?v=8jUuHAaTOZA

I have build this turbine with the objective to produce electricity to charge small devices like smartphone or powering a led strip.
I can't use solar panel because my balcony is lit by the sun 4 hours per day. But luckily for me, i live near the sea and there is constant wind which coming with the tide, so i decided that building a wind turbine can be a good alternative.

This wind turbine is pretty reliable and robust, it survive many storms (wind > 110km/h !) with little damage (some nuts tend to loosen, they were remplace by nyloc).

This wind turbine starts with wind speed of 3m/s (approx .10km/h) with no load.
The measured torque on the shaft is approximately 0.25N.m at 20km/h wind. I think is sufficient to move a stepper motor to produce some electricity but it will increase the wind speed at which the turbine starts.

I am using stepper motor from Digikey (ref 1528-1062-ND) as generator and a full bridge rectifier
Fonte
Thingiverse
Cosa serve per stampare: Intermedio Bassa affidabilità
Pezzo unico Viteria richiesta
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 1/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA
Tempo stimato
4 h
Post-elaborazione
Viteria
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione