Thingiverse
Windmill
von Hcontriver
74
Downloads
47
Likes
0
Makes
For this project you need a plywood plate 5mm thick.
Here i used a laser-cut ( Gravograph LS100IQ) with a tray to 460x305mm, with following params:
Power 100%
Speed 7%
I used hot glue and wood glue to glue the pieces.
At the end the windmill is approximately 15cm tall and has a diameter of 12 cm.
Here i used a laser-cut ( Gravograph LS100IQ) with a tray to 460x305mm, with following params:
Power 100%
Speed 7%
I used hot glue and wood glue to glue the pieces.
At the end the windmill is approximately 15cm tall and has a diameter of 12 cm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!