Thingiverse
Windmill v3 Two Way
von icimdengelen
4
Downloads
7
Likes
0
Makes
Windmill v3 Two Way
v3 design with two propellers, each rotating in different directions
propeller diameter 200mm, thickness 7mm
I used a ring that I designed for the Zwo astronomy cameras. I set the inner diameter of the ring to 50 mm.
You can make the bearings more slippery by spraying oil-rust remover on them.
necessary materials
2x 608zz bearing
1x m4 30mm bolt
2x m4 10 or15mm bolt
1x m6 15 or 20mm bolt
1x m6 nut
1x m3 10 or 12mm bolt
1x m3 flat washer
https://youtu.be/3RJXR8bVDws?si=OoEIQJbhS7HzkvBd
if you want to support
https://www.crealitycloud.com/model-detail/wind-propeller-v3-two-way?source=22
v3 design with two propellers, each rotating in different directions
propeller diameter 200mm, thickness 7mm
I used a ring that I designed for the Zwo astronomy cameras. I set the inner diameter of the ring to 50 mm.
You can make the bearings more slippery by spraying oil-rust remover on them.
necessary materials
2x 608zz bearing
1x m4 30mm bolt
2x m4 10 or15mm bolt
1x m6 15 or 20mm bolt
1x m6 nut
1x m3 10 or 12mm bolt
1x m3 flat washer
https://youtu.be/3RJXR8bVDws?si=OoEIQJbhS7HzkvBd
if you want to support
https://www.crealitycloud.com/model-detail/wind-propeller-v3-two-way?source=22
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
